If your Infinix Smart 10 X6725B is stuck on the logo, facing boot loop issues, or you simply want to restore it to factory condition, flashing the stock firmware is the ultimate fix. In this article, I’ll walk you through everything you need—from downloading the correct ROM to flashing it safely using SP Flash Tool.
📌 Why Flash the Infinix Smart 10?
Flashing the official firmware can solve:
- Boot loop or stuck-on-logo issues
- FRP (Factory Reset Protection) lock
- Lagging or crashing system
- Virus or malware infection
- Dead recovery or soft-bricked device
- Unwanted root or custom ROMs
It’s like giving your phone a fresh start!
📦 Firmware Details
| Specification | Info |
|---|---|
| Device Name | Infinix Smart 10 |
| Model | X6725B |
| OS Version | Android 13 (XOS 13) |
| Chipset | MediaTek Helio G37 |
| File Format | Scatter file (.txt) |
| Flash Tools | SP Flash Tool, Miracle Box, CM2, Hydra, UMT |
Note: Always use firmware specific to model X6725B. Flashing the wrong file can brick your device.
🧰 Required Files & Tools
Before flashing, make sure you have:
- ✅ Official firmware (ROM) for X6725B
- ✅ SP Flash Tool v6 or higher
- ✅ MediaTek USB VCOM drivers
- ✅ Windows PC (recommended)
- ✅ USB cable
- ✅ 7-Zip or WinRAR to extract files
🔧 How to Flash Infinix Smart 10 X6725B
Step 1: Download & Extract Firmware
👇 𝗖𝗹𝗶𝗰𝗸 𝗛𝗲𝗿𝗲 𝗧𝗼 𝗗𝗼𝘄𝗻𝗹𝗼𝗮𝗱
Step 2: Install USB Drivers
- Install MediaTek VCOM drivers on your PC
- Restart your system after installation
Step 3: Launch SP Flash Tool
- Open
flash_tool.exe - Load the scatter file from the firmware folder
Step 4: Configure Flash Settings
- Select “Download Only” mode
- Load DA and AUTH files if required
Step 5: Connect Your Phone
- Power off the device
- Connect via USB while holding Volume Down or Up
- SP Flash Tool will detect and start flashing
Step 6: Wait for Completion
- Do not disconnect until you see the green checkmark
- Reboot the phone and complete setup
🧪 Common Errors & Fixes
| Error | Solution |
|---|---|
| BROM ERROR: S_FT_ENABLE_DRAM_FAIL | Use correct DA file and scatter |
| Device not detected | Reinstall drivers or change USB port |
| Stuck on logo | Perform factory reset from recovery mode |
إرسال تعليق